Honeywell DCS Engineering Services

Honeywell Experion PKS Engineering & Support

NL Automation provides comprehensive Honeywell Experion PKS DCS engineering services, covering the full spectrum from initial control strategy development through to commissioning and ongoing lifecycle support. Our team has deep hands-on experience configuring C300 controllers, developing Control Modules, building HMI graphics and executing FAT/SAT activities.

Engineering Services

• Control Module (CM) configuration, modification and standardization across control strategies
• C300 controller engineering and control strategy implementation for process units
• PID loop configuration, cascade control and advanced control-logic development
• Sequence and procedural logic development for start-up, shutdown and cleaning sequences
• Interlock, permissive, status and operator-command logic design and implementation
• DCS database engineering — point creation, parameter assignment and tag management
• HMI/Station graphics development — operator displays, faceplates and navigation
• Alarm configuration, event logging, status displays and diagnostic support setup

Testing & Commissioning

• Logic simulation and engineering verification prior to FAT
• FAT procedure preparation, test execution and punch-list management
• SAT, field loop-check support and pre-commissioning activities
• Commissioning support — control-loop verification, start-up assistance and first-fill support
• Troubleshooting of control strategies, operator graphics and system communications
• Controlled online modifications under approved site management-of-change procedures